This is the knuckle set you've been looking for.  Use the drop down menu to add ball joints and/or spindle studs to the package.  If you opt to get the ball joints as part of the package, you will be receiving Parts Mike's proprietary hardcore ball joints.  Check out our steering arm packages to complete the set up, and call us if you have ANY questions!  We're steering experts, there's a lot of gotchas, and it's easier to solve a problem before it happens then figure out how to fix a failed attempt AND the original problem. 

These are left and right knuckles for a GM Dana 44 ball joint axle, and are NOT your standard knuckles. These have been specifically designed for increased strength over an OE knuckle. A six stud GM spindle fits perfectly, and they come milled, drilled, and tapped for full high steer.  The steering arm surface is about half an inch taller to additional steering clearance.  They are designed with threaded holes for steering stops on both sides of each knuckle!  This means that each knuckle has a stop for turning either direction at full lock.

WARNING: THESE KNUCKLES DO NOT HAVE AN ARM FOR A TIE ROD. They require two steering arms and the necessary hardware for a full high steer setup. You will need to purchase the steering arms and hardware separately.